63 • Schlage • Schlage Utility Soware User's Guide
Glossary
FC Mode
Allows access by Facility (Site) code.
First
The first query an access point makes to a PIM400/401 or Legacy PIM occurs immediately following
a card swipe. - “First” is the amount of time, in milliseconds, an access point should wait before
making its second query to a PIM400/401 or Legacy. This setting should be slightly greater than the
fastest response time from the access control panel or host. This optimizes battery life and system
performance.
GUI
Acronym for Graphical User Interface.
Heartbeat
The time interval that access points communicate to PIM400/401 or Legacy PIM when there is no
activity. Affects battery life.
Hi Lo Output
These settings control the PIM400/401-TD2 open collector outputs sent to an access control panel
on detection of Request-to-Exit (RTX), Door Position Switch (DPS), and Trouble. The WPIM switches
these signals between an open collector and ground state.
Latch Type
Configuration of an access point depending on lock or latch type issued or used.
Mode
Configuration of an access point for standard operation or for factory testing.
No Purge
Reader will remember the first 20 cards swiped for degraded mode access.
PIM
Acronym for Panel Interface Module.
PIV
Acronym for Personal Identification Verification, refers to control and security standards set by
the National Institute of Standards and Technology (NIST) for Federal employees and long-term
contractors.
Relatch Time
The interval between the unlocking and relocking of an access point. Controlled by the access point,
not the host system.
Relock delay
The time span from unlocking a lock aer presenting a Credential until relocking. The relock delay can
be set for each Door individually between 1 and 254 seconds. The relock delay setting is transferred to
the lock through the program file.
TSA
Acronym for Transportation Security Administration.
Komentarze do niniejszej Instrukcji